The last step in the installation process is to open up the project you are currently installing in Studio and verify that all sensors are reporting and that the signal strength for the whole installation is good.
If all sensors are reporting with no warnings or indications on the signal strength, the installation is complete. If one or more sensors are in boost mode(boost icon) or are not reporting (no signal icon), go to troubleshooting.
Visual troubleshooting
If a sensor is transmitting in boost mode (boost icon), using high energy transmissions, the sensor will be listed as shown below.
Placing an additional Cloud Connector closer to the sensor in boost mode (boost icon) will allow the sensor to report in normal mode. The sensor transitions between transmission modes automatically.
Cloud Connector cellular connection
When a Cloud Connector that supports cellular is connected through the built-in cellular modem, we recommend reviewing the connection after some time. DT Studio provides historical data on the Cloud Connector cellular connectivity.
The illustration below shows one acceptable installation with a slightly low average signal strength, but with few connection drop-outs, and one unacceptable installation where the signal strength is sufficient, but connection drop-outs occur periodically. Periodic drop-outs like this may indicate that the power socket in use is powered down each night, and is not suitable to power the Cloud Connector.