Removing DT sensors requires care to avoid damaging them. Follow the steps below to safely detach a 19mm sensor so it can be reused.
Who is this article for?
Anyone who needs to remove a 19mm DT sensor from a surface without causing damage.
What do you need?
- A tool with a square hole matching the sensor dimensions (19mm) - such as a wrench or spanner that closely fits
Steps
- Use the right tool. The best tool has a square hole matching the 19mm sensor dimensions, allowing you to grip the sensor securely without excessive force. A wrench or spanner that closely matches the size works as an alternative.
- Do not use sharp tools. Never use knives, screwdrivers, or similar tools to pry the sensor off. These can cause irreparable damage.
- Twist gently. Start by gently twisting the sensor back and forth to loosen the adhesive. Apply steady, gentle pressure — do not force it.
- Pull slowly. Once the sensor begins to loosen, continue twisting while gently pulling it away from the surface.
Consider Mounting Brackets for future installations
Using Mounting Brackets makes future removal much easier and safer, while also improving radio signal strength.